Hobart Peeler 6460

STANDARD FEATURES
■ Stainless steel housing for durability
■ Silicon carbide abrasive disk easily removed for
cleaning
■ Stainless steel drive shaft
■ Gray molded, heavy-duty hopper cover with
opening to monitor product
■ Peels 30 lbs. (Model 6430) or 50-60 lbs. (Model
6460) in one to three minutes
■ Heavy-duty motors for high volume, long life
■ 3⁄4 H.P. (Model 6430) or 1 H.P. (Model 6460)
motor
■ V-belt direct speed drive
■ Stainless steel construction
■ NSF approved removable Lexan liner
■ Synchronous 5 minute timer (single phase only)

SPECIFICATIONS
MOTOR: 3⁄4 H.P., Model 6430; 1 H.P. Model 6460. The motor
features manual reset overload protection, grease-packed ball
bearings, and ventilation within the peeler enclosure. Single
phase is capacitor-start, induction run, and three phase is polyphase,
squirrel-cage, induction-run type.
ELECTRICAL SPECIFICATIONS: 115/60/1, 200-230/60/1,
200-230/60/3 UL Listed. 220-240/50/1, 380-415/50/3—Not
submitted for UL Listing.
SWITCH: Manual tumbler type, located on right side of
discharge
chute as standard. Switch can be relocated to other
side of chute if desired.
TIMER – Models 6430T and 6460T: Synchronous
5-minute
timer, adjustable for any increments from 1⁄2 minute up to
5 minutes, with 15-second markings etched on a large timer
dial. This timer is furnished only in single phase specifications
as standard.
DRIVE: Multigrip, poly V-belt provides the direct speed reduction
between motor and peeling disc. Belt adjustment may be
accomplished from outside the machine. The stainless steel
drive shaft is rigidly mounted on grease-packed ball bearings.
Advanced designed triple protection sealing prevents entrance
of water into shaft bearings.
PEELER UNIT: Cylindrical construction, heliarc-welded stainless
steel with removable NSF approved Lexan liner. A one
piece, reinforced plastic
molded, lightweight, easily removable,
positive locking hopper cover is provided for easy cleaning.
Quick-opening removable aluminum hopper door and positive,
cam-type pressure lock. Discharge chute is ball burnished cast
aluminum. To facilitate
installation, the peeler unit can be positioned
at 90° intervals, in relation to the peel trap unit.
ABRASIVE DISC: An extremely lightweight fiberglass
reinforced plastic disc is 201⁄2 inches in diameter. The
silicon-
carbide abrasive is permanently bonded to the disc, assuring
unequaled long service. Disc can be easily and quickly
removed for cleaning by removing the lightweight hopper
cover. Two angle mounted wipers provide positive movement
of waste into the outlet.
WORKING CAPACITY: Model 6430 peels 30-33 pounds in one
to three minutes. Model 6460 Peeler peels 50-60 pounds in
similar time.
FINISH: Peeler and peel trap unit are glass-beaded stainless
steel. Plastic
molded hopper cover is gray. Door and handle,
discharge chute, and legs are cast aluminum and ball burnished
for durability. Bottom of peeler unit is cushioned in
resilient rubber trim molding.
WATER INLET: The inlet is the air-gap type, mounted at the
rear of the peeler unit at sufficient height to meet plumbing
codes. The water from the inlet impinges on the curved surface
of the hopper cover to form a fan pattern of water into the unit.
This design promotes interior self-cleaning and forms a water
curtain which prevents undesirable splash.